Ampere Pro 1.55.6 APK Download Free [LATEST]

By | November 24, 2015

Ampere Pro 1.55.6

Ampere Pro 1.55.6 APK Download Free [LATEST]

Ever before actually we feel, that a person charger / USB wire fees set your device really fast, and the other not? Now, you can check this with Ampere. Measure the request and also the current release of the battery. The application runs on Android 4.0.3+ tools. Not every device is supported because there are devices that do not have adequate chip dimension (or interface) and who can not be assisted at all. Please see the list of compatible phones not the end of the description.

The application is not intended to be accurate mA. It is only good for review the combination charger cable / USB is working best for you in the exact same device. Start the application and wait ca. 10 seconds (“calibrating” is on the monitor). Then time certainly will be released the loading or unloading of today.

Pro Features

Alerts on the device
Alerts Android Wear
The current depends on many things

The battery charger (USB / AC / Wireless)
The USB cable
The type of phone
Current tasks running
Present brightness
State WiFi
State GPS
Please do not use the readings in this application as concrete science. However, the readings are good enough to measure relatively how various chargers and USB cables just in the same device.

Unfortunately, some Samsung devices do not give correct values (measures) (eg S5), just the maximum load current with setting actual cable / USB charger. This is a firmware problem.

Background Information

The application measures the charge / discharge of the battery. If your phone is not connected to a charger, the discharge current is negative. If a charger is connected then the current so the charger provided will be used to supply the telephone and the remaining energy will be charged in the battery.

If your phone consumes 300 mA without connected charger (-300mA on the screen), then a 500 mA charger charge your battery maximum 200 mA (200 mA on the screen).

Technical information

The current shown is an average value of 50 measurements least the top 10 values and the 10 lowest values. The current shown may be unstable or unstable, or even zero, which means that the Android system provides such unstable values. Each company uses different types of batteries and other equipment so it is difficult to get accurate results on its charger.

Phones / ROMS informed that you are not working with this application

Galaxy Grand Prime – fortuna3gdtv
Galaxy Note 2 – t03g, t03gchn, t03gchnduos, t03gcmcc, t03gctc, t03gcuduos
Galaxy S3 – d2att, d2spr, d2vmu
TAB4 Galaxy 7.0 – degas3g
HTC Desire 510 – htc_a11ul8x26
HTC One S (Ville), X (endeavour), XL (Evita)
HTC Sensation 4G – Pyramid
NOTE: If the measured value is always 0, try using the “old method of measurement” and / or the settings of “interface as” options (if available).

LiPo batteries do not extract the maximum for the entire time it takes to charge the phone. If the battery is almost fully charged, then the charging current will be much less as low battery levels.



New: Warning tone selector added
New: Max. This detection USB feasible added
New: System Information (Touch 6 times the version Build Settings / About Ampere)
System conversion temperature level remedied
Corrections insects

How to install?
Download Apk (link below).
On your Android device, go to Settings> Security> allow unknown sources.
APK is downloaded to your phone and installs it.
All ready. Enjoy!

Screen Shots:-


Download Links

Ampere Pro | Mirror 1 | Mirror 2  | Mirror 3

Leave a Reply

Your email address will not be published. Required fields are marked *